4.
Install the Spout
NOTE:
When installing to finished wall materials that will not support fasteners,
anchors are required. These materials include glass, mirror, and ceramic tile. The
anchors and fasteners are not supplied. Select appropriate fasteners and anchors for
the finished wall material.
If Anchors Are Required
Position the wall flange over the spout plug, with the three holes at the 2, 6, and
10 o’clock positions. Mark the location of the holes in the flange on the wall
material.
Drill holes at each of the marks, using the size and drill bit type appropriate for
the finished wall material.
All Installations
Confirm there are three setscrews pre-installed in the wall flange. Make sure they
do not protrude into the inside diameter of the wall flange. Adjust as necessary.
Apply plumbers putty or other suitable sealant to the back surface of the wall
flange. Refer to the putty manufacturer’s application instructions.
Slide the wall flange over the spout plug (not shown).
Position the three holes on the wall flange at the 2, 6, and 10 o’clock positions,
then secure the wall flange with three wood screws or other appropriate fasteners
(not provided).
Remove the spout plug.
Thread the spout onto the mixer valve until the spout is fully seated. If necessary,
unthread the spout for adjustment.
Escutcheon
Applique
Chapetón
Setscrew/Vis de retenue/Tornillo de fijación
Spout
Bec
Surtidor
Wall Flange/Bride murale/Brida mural
Setscrew
Vis de retenue
Tornillo de fijación
Wood Screws/Vis à bois/Tornillos para madera
Level/Niveau à bulle/Nivel
Apply plumbers putty.
Appliquer du
mastic de plombier.
Aplique masilla
de plomería.
Setscrew/Vis de retenue/Tornillo de fijación
Setscrew
Vis de retenue
Tornillo de fijación
Kallista
9
1156628-2-A
