INSTALLATION INSTRUCTIONS
Bidet Faucet
1260871-2-B
4 of 8
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
2. INSTALL THE DRAIN
Drain Body
Nut
Washer
Gasket
Flange
Apply plumbers
putty.
Link
Stopper Rod
Thumb
Screw
Apply thread sealant.
Tailpiece
Nut
Flange
Nut
Stopper
Clip
Rod
Body
Remove the protective cover from the fl ange.
Apply a ring of plumbers putty or other sealant to the underside of the fl ange according to the putty
manufacturer’s instructions.
Assemble the nut, fl at washer, and tapered gasket (tapered side up) fully onto the body.
From the underside of the fi xture, insert the drain body up into the drain hole.
From the top of the fi xture, securely hand tighten the fl ange onto the drain body.
Make sure the drain body seal hole is facing the back of the fi xture, and securely tighten the nut.
Remove any excess putty or sealant.
Insert the stopper into the fl ange.
For regular installations, insert the short end of the rod into the body seal hole and under the stopper. For
vandal-resistant installations, fi t the rod through the hole in the stopper. Hand tighten the body nut.
Remove and adjust the stopper as needed so it lifts about 3/8” (10 mm) when opened. To adjust, rotate the
threaded stopper rod in or out as needed. Retighten the stopper nut.
Apply thread sealant tape to the tailpiece threads, and thread the tailpiece to the body. Tighten the tailpiece
securely.
Slide one end of the clip on to the rod. Slide the link onto the rod with the thumb screw facing the back of
the fi xture.
