KAKA Industrial TGK-08, Руководство по эксплуатации, Страница: 10 / 44

Please install the machine on the horizontal ground. Although not required, we recommend
that you mount your new machine to the floor.
4.2 Clean up
The unpainted surface are coated with a waxy oil to protect them for corrosion during
shipment. Remove this protective coating with a solvent cleaner or degreaser. To clean
thoroughly, some parts may need to be removed. For optimum performance from your
machine, make sure you clean all moving parts or sliding contact surfaces that are coated.
Note: Gasoline and petroleum products have low flash points and could cause an
explosion or fire if used to clean machinery. Don’t use gasoline or petroleum products to
clean the machinery.
4.3 Work stop
The work stop is easy to adjust and can be set up on the vise, our work stop has three main
parts including the workstop rod, arm and workstop ring.
To install the workstop:
A. Slid the workstop rod in the hole in the base of the vise and tighten the set screw.
B. Slid the arm onto the workstop rod and tighten the set screw.
C. Insert the ring into the rod and tighten the set screw.
Workstop rod
Arm
Set screw
Ring
Figure 4