KAKA Industrial BS-126G, Инструкция по сборке и эксплуатации

Страница: 7 / 20

4.3 Intended and unsuitable uses of the machine
The band sawing machine has been designed and built to cut bars, structural steel and
ferrous metal pipes in accordance with the instructions contained in this manual.
Therefore, the cutting of other materials is not permitted: if the above recommendations
are not observed
，
the machine could be damaged and the health and safety of the
operator put at risk. Cutting is not permitted, if the bar has not been first locked in the
vice.
5. MAIN TECHNICAL DATA
Under no circumstances should the following data be altered, this is in order to protect
the correct functioning of the machine and to avoid creating safety risks for the operator.
MOTOR: Three-phase or single phase
Motor power: 0.75 kw / 1.1 kw
Blade size: 2825 x 27 x 0.9 mm
Cutting angle: 60° right
Drive: gear
Packing size: 163x90x153 cm
N.W / G.W: 380 / 420 kg
6. HANDLING AND TRANSPORTATION
For safe handling and transportation use a lift truck for movement indoors also indicated
on the drawing ? Encl.?. Keep the machine in its normal position and avoid turning it
upside down. If the machine is fastened to the pedestal, stability will be greatly reduced
and therefore all the necessary measures should be taken to stop the machine from
tipping over.
All handling and transportation operations should be carried out by trained staff.
7. MACHINE INSTALLATION
7.1 MACHINE CHECK
The machine should be checked to make sure that it has not been damaged during