7
Center the circular knife by selecting the cuttable spacer ring on the clamping flange.
Now fix the circular knife with the pressure disk and the fixation nut on the clamping
flange (see Picture).
Before tightening up or loosing the fixation nut, the shaft fixation pin must be pressed
down. Turn the motor shaft with the cwrench till the pin locks in the shaft fixation.
!!! Attention when tightening and loosening of the circular knife. Risk of injury !!!
4.
OPERATION
4.1
FIXATION
OF
THE
ROUND
KNIFE
Pressure disk
Clamping nut
Shaft fixation
Shaft
Lynette
Clamping flange
After you have fixed the circular knife, place the lynette on the back of the knife. Align the
lynette in the way that the wheel is turning softly (e. g. circular knife 10°, lynette approx.
15°). Depending on the type of circular knife, you can adjust the angle of the lynette head
correspondingly. The lynette is to support of the circular knife and grants a burr free
bevel.
Place on the
back of the
cutting edge
Adjustment of
angle values
