Kaindl BSG 60, Руководство по эксплуатации, Страница: 9 / 29

6.
OPERTATION
For drills from
3­20 mm
use the prism including the inner jaws. For drills from
20­40 mm
remove the inner jaws.
Removing of the inner jaws:
Loosen the 4 pcs socket head cap screws with a suitable
key SW 2,5 (see picture 2).
Mounting of the inner jaws:
Place the inner jaws inside the prism in the way that the
graduation marks are in line with the outer marks (1 , picture 1 ). The numbers on the jaws
shall not be visible. Softly tighten the fixation screws (picture 2) do not tighten too strong.
9
Loosen clamping screw (2) and pull out the pin (1 ) to the stop dog and fix again.
Depending on the diameter, let the drill project outside the prism (picture 3). Drills from
Ø 3­35 mm
, cutting edge to graduation notch. Drills from
Ø 35­40 mm
, cutting edge to
total length of the pin. Then align the cutting edge parallel to the slantwise graduation line
(picture 4).
For getting a parallel clamping of small drills, we propose to clamp a second drill of same
diameter on the back of the prism. For drills with bigger diameter also use the prism
elongation for the cylindrical part (picture 2, Pos. 1 ). Move back pin (1 ) and fix the screw.
Broken drills, first pre-sharpen till they are flat.
6.1.
CLAMPING AND ALIGNMENT OF
RIGHT HAND SPIRAL DRILL BITS
Picture 1
Picture 2
Picture 3
Picture 4
1
1
2 3
1
2
1
2
3-35
3-40 (40-60)