KAESER SM 8, Руководство по обслуживанию

Страница: 49 / 83

Maintenance
9 --- 46
9.14.4 Procedure for putting back into operation
Refer to chapter 7.7.1 and follow the instructions in section ‘‘Pouring a small quantity
of oil into the air inlet port” .
Refer to chapter 7.7.2 and followthe instructions in section ”Running the compressor
package in idle”.
Refer to chapter 9.10 and follow the instructions in section ‘‘Venting the compressor
package”.
Top off with oil again (see chapter 9.14.2).
Open the shut ---off valve between the compressor package and the air system.
Start the compressor package (see chapter 8.3) and run until working temperature is
reached (see chapter 1.1).
Top off the oil, see chapter 9.12.
Perform a test run
When the operating temperature is reached (see chapter 1.1), shut
down the compressor package (see chapter 8.3) and lock the main
disconnect in the ”off” position in accordance with applicable lock out/
tag out procedures (example: OSHA CFR 29 § 1910.147) to ensure the
compressor does not restart.
Afterwards, carry out a visual check for leaks.
9.15 Changing the Oil Separator Cartridge
The service life of the oil separator cartridge is strongly influenced by the degree of conta-
mination of inlet air and on strict adherence to the recommended maintenance intervals of
the air and oil filters.
We recommend that the oil separator cartridge is changed with the oil or when the relevant
service message / alarm message is displayed on SIGMA CONTROL (see chapter 8.1).
Stop the compressor package under full load (see chapter 8.3).
Lock the main disconnect in the ”off” position in accordance with ap-
plicable lock out/tag out procedures (example: OSHA CFR 29
§ 1910.147) to ensure the compressor does not restart.
Before opening or removing pressurized components (pipes, hoses,
tanks, etc.) it is imperative that the compressor package is completely
depressurized.
Venting the compressor package (see chapter 9.10).