Kaden KMC R32, Руководство пользователя, Страница: 14 / 68

14 | Kaden Owner’s and Controller Manual
Setting angle of air flow
Setting vertical angle of air flow
While the unit is on, use the vertical
SWING
button
to set the direction (vertical angle) of airflow.
• To make the louvre swing up and down continuously, press
and hold the vertical SWING button for 3 seconds. Press it
again to stop the automatic function.
Setting horizontal angle of air flow
While the unit is on, use the horizontal SWING button to set the
direction (horizontal angle) of airflow.
• Press the horizontal SWING button once to activate
the louvre.
Note on louvre angles
When using COOL or DRY mode, do not set louvre at too
vertical an angle for long periods of time. This can cause water
to condense on the louvre blade, which will drop on your floor
or furnishings. (See
Fig. A )
When using COOL or HEAT mode, setting the louvre at too
vertical an angle can reduce the performance of the unit due
to restricted air flow.
Do not move louvre by hand. This will cause the louvre to
become out of sync. If this occurs, turn off the unit and
unplug it for a few seconds, then restart the unit. This will
reset the louvre.
CAUTION
Do not
keep louvre at too vertical an angle for long periods
of time. This can cause water condensation to drip on
your furnishings.
CAUTION
Do not put your fingers in or near the blower and suction
side of the unit. The high-speed fan inside the unit may
cause injury.
Deflector rod
Fig. A
Fig. B
Range