Kaco blueplanet 110 TL3 M1 WM OD IIK0, Руководство по эксплуатации

Страница: 30 / 268

WARNING
Risk of burns from hot housing components
Housing components could heat up during operation.
› Only touch the housing cover of the device during operation.
9.2 Uninstalling the device
DANGER
Dangerous voltage due to two operating voltages
Severe injuries or death may occur if the cables and/or terminals/busbars in the device are touched. The
discharge time of the capacitors is up to 5 minutes.
› Only appropriately qualified electricians authorized by the mains supply network operator are permit-
ted to open and maintain the device.
› Before opening the device: Disconnect the AC and DC side and wait at least 5 minutes.
↻ The device is switched off and a check has been performed to ensure that it is de-energized.
↻ AC cable disconnected AC connection [See section 8.6.1
}
Page 29].
↻
DC connection disconnected DC connection [See section 8.6.2 } Page 29].
1 Undo the cable fittings for Ethernet cables [ W_29].
2 Undo the cable fittings for RS485 cables [ W_19].
3 Disconnect the plug from the communication circuit board.
4 Pull the interface cables out of the device.
5 Insert sealing plugs into all open cable fittings.
»
The device has been uninstalled. Proceed with removal.
9.3 Removing the device
↻
Device has been switched off and uninstalled.
1 Remove the screw that prevents the device from being lifted off the mount.
2 Use the lateral openings and lift the device off the mount.
»
The device has been removed. Proceed with packaging.
9.4 Packaging the device
↻
The device has been uninstalled.
1 If possible, always pack the device in the original packaging. If this is no longer available, an alternative is to use
equivalent packaging.
2 You must be able to close the box completely and it must be able to accommodate the weight and size of the device.
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 110 TL3 KACO blueplanet 125 TL3
KACO blueplanet 137 TL3 KACO blueplanet 150 TL3
Page 30
EN-US