Kabola B-8, Руководство пользователя

Страница: 12 / 20

Use r ma nual Ka bola B-serie, 1-4-2005
12
4.2 Starting your system
When everything is connected follow procedure below:
1.
Connect the boiler to the power supply, the earthed outlet for the 230V AC version and the
battery for the 24 V DC version.
2. Switch the boiler on with the on/off switch on the dashboard. The lamp in the switch will
indicate that the system is active. This lamp is not present in the 24 V DC version.
3. Set the required boiler temperature between 55 and 90°C using the boiler thermostat.
4. Set the room thermostat so that it is switched on. (See manual of the room thermostat)
5. Start the oil burner (figure 11)
5.1 Open the valve of the fuel tank (5)
5.2 Open the valve on the oil filter (5A)
5.3 Install the bleeding hose (3C) on the bleeding opening of the filter
5.4 Start the oil burner.
5.5 The burner switches on, when the burner is fitted with a pre-heating element, this will
take 1,5 minutes.
5.6 Open the bleeding valve on the oil filter.
5.7 Check if oil is coming out of the hose.
5.8 Check all oil connections for leakage’s.
5.8.1 W hen the burner won’t start, the control light (8) will light.
5.8.2 close the bleeding valve (3B) on the filter.
5.8.3 W ait approximately 3 minutes.
5.8.4 reset the burner by pushing button (8) and return to 5.4 (repeat if necessary)
5.9 Close the bleeding (3B) when only oil and no bubbles come out of the hose.
Atte ntion: The oil burner is tested by the manufacturer, not adjusted. The adjustment of the burner has
to be done by an experienced installer, because this requires expert knowledge. To be eligible for
warranty, the boiler has to be adjusted by an approved installer. Contact Kabola Heating Systems or
your importer to make an appointment.
Never adjust the burner using your own initiative .
A correctly adjusted burner shows a clear white flame, which is visible through the inspection opening (6)
5 Operating the boiler
When the boiler has been started and adjusted according to 4.2, operation of the boiler is very simple.
The required temperature is set with the room thermostat, which regulates the boiler. The operation of
the thermostat is explained in the manual of the room thermostat.
If problems arise with the operation of the boiler, you will find a list of possible problems and solutions in
Appendix D.
6 Cleaning and maintenance
6.1 Points of attention
Spare parts must be ordered through your importer dealer or from Kabola Heating Systems. For
warranty purposes only original spare parts may be used. When ordering spare parts, mention the type
of the boiler and its serial number. Kabola Heating Systems will then be able to deliver the correct parts.
In Appendix B, the main spare parts are listed.