14
For each of the commands that displays either current or historic Date and Time
(#71, #72, #78, and #79), the format is the same: Starting from the largest time
increment (4-digit Year) and moving down to the smallest (2-digit second). For
readability, the date and the time are broken apart by the “
Hr-
” (hour) prompt in the
middle. (For example, “
UtC
”, “
Yr-
”, “ 20”, “ 09”, “ 12”, “ 25”, “
Hr-
”, “ 22”, “ 30”, “
59”)
DISPLAY DOOR CONTACT SWITCH STATUS (#74)
The Gen2 lock has a 4-pin signal input cable to optionally use Door Contact switches
and for a Remote Disable function. After installing the door contact switches, the
customer will want to determine the status of these sensor, often while the lock is still
in factory mode, and later when the lock is activated.
(For example, “
OPd
” for “OPened door”, “
CLd
” for “closed door”, or “
nCC
” for “no
door contact connection” accordingly.)
Note:
Check for Remote Disable Signal by entering 50-25-50 and looking for
“
rLO
” on display before closing door.
#75: Display bolt works sensor contact switch status
The Gen2 Swingbolt lock has a 6-pin alarm input cable to optionally use
Door Contact switches, mandatory Bolt Works Contact Switches, and for a
Remote Disable function. After installing the bolt works contact switches, the
customer will want to determine the status of these sensor, often while the
lock is still in factory mode, and later when the lock is activated (For
example, “bSE” for “Bolt Works Sensor Extended”, “bSr” for “Bolt Works
Sensor Retracted”, or “nCC” for “no bolt works sensor contact
connection” accordingly).
