RX-B/RX-D
User Manual
Specifications
2
Installation
4
www.kaadasgroup.com
Shenzhen Kaadas Intelligent Technology Co.,Ltd reserves all rights
for the final interpretation to this user manual
All design and specifications are subject to change without notice.
Installation Guide
1
Backup key
Exterior assembly
Bolt
Cross bolt
Interior assembly
Battery
cover
Mounting
plate
Mounting
screws(3)
screws(2)
Keypad
Battery cover
Wireless module
socket
Reset button
Manual mode
Cylinder
Micro USB port
Reboot button
Interior assembly
Interior assembly
Exterior assembly
Exterior assembly
Preparing for Installation
3
Optional Bolt
Faceplate
Addtional Parts
Tools Needed
Lock installation
#2 Philips screwdriver
Important Notice:
Make sure your door is prepared prior to installation.
Only drill a upper hole if you wish the lock to have
added stability. Please refer to the provided templatefor
drilling if needed.
Door prep
1. 2-1/8” (54mm) hole saw
2. 1” (26mm) boring bit
3. 7/64” (2.5mm) drill bit
4. 3/8” (10mm) drill bit
5. Chisel&Hammer
B. Change faceplate,if necessary.
No change
necessary
A. Measure the dimension of the hole shown.
φ2-1/8”
(54mm)
No adjustment needed.
C. Adjust the deadbolt.
NOTE: Bolt ships with backset in 2-3/8”(60mm) position. If required, turn the bolt case and pull to extend to 2-3/4”
(70mm)backset position. (see picture below).The bolt must be in retracted(unlocked) position when you are changing
backset.
1. Install latch.
NOTE: Make sure latch angle faces door jamb.
2. Install strike onto door jamb.
Jamb
Jamb
OR
3. Install crossbolt.
4. Install keypad.
5. Positon the inside
mounting plate by
first routing the
cable and connector
through the
mounting plate’s
cable hole. Secure
both assemblies
using 8/30 screws.
6. Attach cable
assembly to the
interior assembly
PCB by lining up
notches on top
of cable connector
to slots on PCB
connector. Press
connector in firmly
using thumbs untill
commpletely
connected.
PCB connector
Cable connector
169mm(L)x157mm(W)x64.7mm(H)
182.4mm(L)x157.5mm(W)x69.3mm(H)
Operation temperature：
-4°F to 129°F(-20°C to 55°C)
Last up to six mouth
(10 times open/close per day)
AA alkaline battery X 4
(Operation voltage: 4.6~6.0V)
Battery(not included)
φ2-3/4”
(70mm)
φ2-3/4”
(70mm)
φ2-3/8”
(60mm)
φ2-3/8”
(60mm)
Strike
Angle
Wood Block
(Not included)
