NOTES
1. TRIM CAN BE MOUNTED UP, DOWN, HORIZONTALLY OR VERTICALLY.
2. USES STANDARD 161 DOOR PREP.
3. VISION LITE MUST BE AT LEAST 6" FROM CENTERLINE OF TRIM.
8
7
1
2
1
2
3
4
PULL SIDE HANDLE ASSEMBLY
1
4
1/4-20 NUT W/ NYLON WASHER
LATCH
1
PUSH SIDE HANDLE ASSEMBLY
1
1/4-20 x 2-1/2" TRUSS HD. M.S.
4
8-32 x 3/8" FHMS
6
COVER
2
8
1
2
4
3
6
7
5
QTY
PART DESCRIPTION
ITEM
#8 x 3/4" FHWS
2
PATENT No. 6,196,599
US
R
C
L
LISTED
U
c 2017 ABH Mfg., Inc.
printed in USA
www.abhmfg.com
E-mail: [email protected]
Architectural Builders Hardware Mfg., Inc.
1222 Ardmore Ave., Itasca, IL 60143
630.875.9900; FAX 800.9FAXABH (932.9224)
O
R
6000
REVISED 05-19-17
6000-1-14.DWG
VERIFY CORRECT BACKSET AND HORIZONTAL
OR VERTICAL MOUNTING BEFORE DRILLING.
THEN USE BACKSET TEMPLATE THAT IS SUPPLIED.
HORIZONTAL
BACKSET
WITH 7"
HANDLES
BACKSET
HANDLES
HORIZONTAL
WITH 5" OR 7"
DOWN
HANDLES
UP
HANDLES
PUSH
PULL
HANDLES
MIXED
PULL
PUSH
INSTALLATION INSTRUCTIONS:
1. Prep door according to latch backset and determine if trim is to be mounted horizontal or vertical mounting using backset template.
2. Install latch using either wood (item 5) or machine screws (item 2) depending on door type.
3. Install trim:
A) Test both handle assemblies to determine which is the push or pull type.
B) Select the pull handle assembly (item 8) first.
C) Place pull handle on pull side of the door and slide cam shaft into latch cam. Then place the push side handle assembly (item 4)
on the push side of the door. Slide push side cam shaft into latch cam. By hand, fasten both trim handles with (4) 1/4-20
machine screws (item 3) and (4) 1/4-20 hex nuts (item 7). Test both handles for free movement of the latch bolt before
tightening all screws. If latch bolt does not extend or retract freely because of any type of binding, loosen mounting screws to
adjust alignment of trim handles and re-tighten screws one at a time while checking latch bolt movement from both handles.
D) Test for proper operation and check that the mounting hardware (item 3) & (item 7)
is tight
before proceeding with the next step.
E) Place covers (item 1) over push and pull trims and secure with (2) 8-32 flat head screws (item 2) on each cover
.
9
9
REF
SPRING
PIN & COTTER PIN
REF
10
CAM SHAFT
**
*
*
PAGE 1 OF 3
6
LATCH CAM
2
5
SQUARE
-OR-
ROUND
COVER
6000 SERIES INSTALLATION
ALL PREP MOUNTING HOLES
TO BE STRAIGHT & PARALLEL
TO ONE ANOTHER, THIS WILL
HELP PREVENT ANY BINDING
OF MECHANICAL PARTS.
10
NOTE:
BEFORE MOUNTING BASE ASSEMBLIES
CAM PIN MUST BE ROTATED TOWARDS
SIDE INDICATED BY ARROW STAMPED
ON THE BASE.
PUSH
CAM SHAFT
PULL
DETAIL "A"
