1-16 (No.MB496)
3.1.16 Removing the MD mechanism assembly
(See Figs.18 to 20)
• Remove the rear cover(B), side panels(L)/(R), top cover as-
sembly, front panel assembly, heat sink(B) and main board.
(1) From the both side of the main body, remove the four
screws
V
attaching the MD mechanism assembly. (See
Figs.18 and 19.)
(2) From the top of the main body, disconnect the card wire
from the connector
CN803
on the joint board. (See Fig.20)
(3) Take out the MD mechanism assembly from the main
body.
3.1.17 Removing the MD holder
(See Fig 20)
• Remove the rear cover(B), side panels(L)/(R), top cover as-
sembly, front panel assembly, heat sink(B), main board and
MD mechanism assembly.
(1) From the top side of the main body, remove the shield(MD).
(2) Remove the two screws
W
and screw
X
attaching the MD
holder to the micon board.
(3) Take out the MD holder from main body.
Fig.18
Fig.19
Fig.20
MD mechanism assembly
V
V
MD mechanism assembly
Joint board
MD holder
Micon board
Shield(MD)
W
X
W
CN803
