No. 51961
TM-H1950CG
18
3.
HOW TO OPERATE EACH SERVICE MENU ITEMS
■
SIGNAL BLOCK
①
In the <BLOCK SELECT> screen, press the
CHROMA/PHASE
key.
②
Then SIGNAL BLOCK adjustment mode screen is displayed (Fig. 7).
③
The original front key function replaced with the different func tion
displayed at the lower side of the s creen as s hown below.
Refer to the illustration given below, the function about each key in
this mode.
④
In this mode,
UNDER SCAN
key is the switch of the screen display. If
necessary, you can shut off the display. Carefully, values of
adjustment items are changed while shut off the screen display.
⑤
Press the
MENU
key, then exit the SIGNAL BLOCK s creen to return
to the <BLOCK SELECT> screen.
■
WHITE BALANCE BLOCK
①
In the <BLOCK SELECT> screen, press the
CONTRAST/BRIGHT
key.
②
Then WHITE BALANCE menu screen is displayed (Fig. 8).
③
In this case, key function is replaced as shown below. There are
several modes of WHITE BALANCE adjustment. Select the various
WHITE BALANCE mode from this menu screen.
④
Press the
MENU
key few times, then exit from the WHITE BALANCE
BLOCK screen to return to the <BLOCK SELECT> screen.
***
***
***
***
< S01 > :
EXIT DISP
SIGNAL BLOCK
***
***
***
***
< S01 > :
EXIT DISP
Fig. 7
< Fu nction Display >
Service number indic ated
Setting value indicated
< Front Panel Key Arrangement >
Select the Service Number
Data operate (inc/dec) key
Adjustment mode exit key
Display on/off switch
CUTO
W01
EXIT
65-D 93-D
WHITE BALANCE BLOCK
<ITEM SELECT >
CUT O F F :CUT O
6500 DRIVE : 65 -D
9300 DRIVE : 93 -D
CUT O
W 0 1
EXIT
6 5-D 9 3 -D
Fig.8
<Function display>
<Front Panel Key Arrangement>
Select the CUTOFF mode
Select the 6500 DRIVE mode
Select the 9300 DRIVE mode
Select the various item nodes
Adjustment mode exit key