JVC RX-E100RSL, Инструкция по эксплуатации

Страница: 21 / 50

18
DVD STB VCR TV TAPE FM/AM
TV DIRECT
DVD
MEMORY
CONTROL
ADJUST SETTING
STANDBY
D I G I T A L
D I G I T A L
S U R R O U N D
INPUT
ANALOG/DIGITAL
INPUT ATT
MASTER VOLUME
SURROUND
ON/OFF
DSP
MODE
ANALOG PRO LOGIC
SUBWFR LFE
SLEEP RDS EON TA ST TUNED INFO HEWS MUTING
MH
Z
KH
Z
VOL
AUTO
DGTL AUTO
INPUT ATT
DSP
L C R
LS S RS
LPCM
DOLBY D
DTS
RX-E100R
DVD STB VCR TV TAPE FM/AM
HOME CINEMA CONTROL CENTER
STANDBY/ON
SETTING
Basic Settings
CONTROL
5
/
∞
/
3
/
2
Display
Low Frequency Effect Attenuator — LFE
If the bass sound is distorted while playing back software using
Dolby Digital or DTS Digital Surround, follow the procedure below.
• This function takes effect only when the subwoofer (LFE) signals
come in, (with “SUBWFR” set to “YES”).
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
settings.
2
Press CONTROL
∞
(or
5
) repeatedly until “LFE
(Low Frequency Effect)” (with the current
setting)
*
appears on the display.
* “0” is the initial setting. If you have already changed the
setting, “–10dB” will be shown.
3
Press CONTROL
3
(or
2
) to select the LFE
attenuator level.
• Each time you press the button, the LFE attenuator level
changes as follows:
0dB : Normally select this.
–10dB : Select this when the bass sound is distorted.
SETTING
CONTROL
C
VOL
O
ANALOG
PRO LOGIC
SUBWFR LFE
VOL
DGTL AUTO
INPUT ATT
DSP
L C R
LS S RS
LPCM
DOLBY D
DTS
CONTROL
Setting Auto Surround
Surround mode is automatically activated when a multichannel
signal comes into this unit through the digital terminal.
You can enjoy Surround mode simply by selecting the source (with
digital input selected for that source) — Auto Surround.
To activate Auto Surround, follow the procedure below.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
settings.
2
Press CONTROL
∞
(or
5
) repeatedly until
“AUTO SR (Auto Surround)” (with the current
setting)
*
appears on the display.
* “OFF” is the initial setting. If you have already changed the
setting, “ON” will be shown.
3
Press CONTROL
3
(or
2
) to select “ON” (or
“OFF”).
• Each time you press the button, Auto Surround turns “ON” or
“OFF.”
Remote
NOT
SETTING
ANALOG PRO LOGIC
SUBWFR LFE
VOL
DGTL AUTO
INPUT ATT
DSP
L C R
LS S RS
LPCM
DOLBY D
DTS
O LOGIC
VOL
TL AUTO
UT ATT
P
CONTROL
CONTROL
EN10-19.RX-E100RSL[B]_f 01.3.8, 2:50 PM 18