JVC RX-E100RSL, Инструкция по эксплуатации

Страница: 17 / 50

14
Basic Settings
DVD STB VCR TV TAPE FM/AM
TV DIRECT
DVD
MEMORY
CONTROL
ADJUST SETTING
STANDBY
D I G I T A L
D I G I T A L
S U R R O U N D
INPUT
ANALOG/DIGITAL
INPUT ATT
MASTER VOLUME
SURROUND
ON/OFF
DSP
MODE
ANALOG PRO LOGIC
SUBWFR LFE
SLEEP RDS EON TA ST TUNED INFO HEWS MUTING
MH
Z
KH
Z
VOL
AUTO
DGTL AUTO
INPUT ATT
DSP
L C R
LS S RS
LPCM
DOLBY D
DTS
RX-E100R
DVD STB VCR TV TAPE FM/AM
HOME CINEMA CONTROL CENTER
STANDBY/ON
Display Source indicators
INPUT
ANALOG/DIGITAL
Source selecting buttons
(DVD, STB, TV)
SETTING
CONTROL
5
/
∞
/
3
/
2
If the following symptoms occur while playing Dolby Digital or
DTS Digital Surround software with “DGTL AUTO” selected,
follow the procedure below.
• Sound does not come out at the beginning of playback.
• Noise comes out while searching or skipping chapters or tracks.
1
Press one of the source selecting buttons (DVD, STB, or TV) for
which you want to change the input mode.
2
Press INPUT ANALOG/DIGITAL (or
ANALOG/DIGITAL INPUT) to select the digital input mode
(DGTL AUTO).
3
Press CONTROL
3
(or
2
) to select “DGTL
D.D.” or “DGTL DTS” while “DGTL AUTO”
still remains on the display.
• Each time you press the button, the digital input mode changes
as follows:
DGTL AUTO : Select this for the digital input mode. The unit
automatically detects the incoming signal
format. (The DGTL AUTO indicator lights up
on the display, then the digital signal indicator
for the detected signals lights up.)
ANALOGUE
: Select this for the analogue input mode. (Initial
setting when shipped from the factory.)
• To play back software encoded with Dolby Digital, select
“DGTL D.D.”
• To play back software encoded with DTS Digital Surround,
select “DGTL DTS.”
Note:
When you turn off the power or select another source, “DGTL DTS”
and “DGTL D.D.” are canceled and the digital input mode is
automatically reset to “DGTL AUTO.”
The following are the analogue/digital signal indicators on the
display to indicate what type of the signal comes into the unit.
ANALOGUE : Lights when the analogue input is selected.
LPCM : Lights when Linear PCM signals come in.
DOLBY D
: • Lights when Dolby Digital signals come in.
• Flashes when “DGTL D.D.” is selected for
software not encoded with Dolby Digital.
DTS : • Lights when DTS Digital Surround signals
come in.
• Flashes when “DGTL DTS” is selected for
software not encoded with DTS Digital
Surround.
Note:
When “DGTL AUTO” cannot recognize the incoming signals, no digital
signal indicators light up on the display.
DVD STB VCR TV DVD
INPUT
ANALOG/DIGITAL
INPUT ATT
Remote
NOT
SUBWFR LFE
MU
MH
KH
VO
DGTL AUTO
L C R
LS RS
DOLBY D
When “DGTL D.D.” or “DGTL DTS” is
selected, “AUTO” goes off.
CONTROL
EN10-19.RX-E100RSL[B]_f 01.3.8, 2:50 PM 14