JVC GY-DV500, Инструкция по эксплуатации

Страница: 41 / 96

41
5. PREPARATIONS
LIGHT
ON
OFF
COUNTER
CTL
TC
UB
RESET
OPERATE/WARNING
MONITOR
SELECT
M
ONITOR
CH-1 CH-2 AUDIO
LEVEL
E
REV FWD
F BATT
H
H M
M S F
REMAIN
AUD LOCK
32k
CH 1
CH 2
48k PB NDF
AUTO OFF DEW
L i RF SERVO
HOLD
SP
MENU
OVER
OVER
40 30 20 10 0 dB
TC GENERATOR
FREE
REC
PRESET
REGEN
CH-1
CH-2 CH-1
CH-2
CH-1 CH-2 CONTINUE MENU
PRESET ADVANCE SHIFT HOLD
AUTO
MANUAL
FRONT
REAR
DATA SET SELECT ITEM GROUP
AUDIO SELECT
AUDIO INPUT
AUDIO
LEVEL
LITHIUM BATT.
Lithium battery compartment
2.
COUNTER
switch
3.
HOLD
button
4.
SHIFT button
5.
PRESET button
4.
ADVANCE button
H M S
HOLD
H M S
HOLD
H M S
Time display (COUNTER switch: TC)
Hour Min. Sec.
HOLD
HOLD
Date display (COUNTER switch: UB)
Month Day Year
n
Check that the lithium battery has been inserted.
5-3 Setting the Date and Time
The date and time of the built-in clock should be set. During shooting, the date and time data are recorded in the sub-time code area
on the tape.
During playback, the data are shown on the counter display. Powered by the backup lithium battery, the set date and time data
continue to count even when the power is switched off.
1.
Turn ON the power and set the counter display to the date/
time mode.
• Set the VCR Setup Menu item No. 516 DISPLAY SELECT
to “CLOCK”.
☞
See “Displaying and Setting VCR Setup Menus” on
page 67.
☞
See “VCR Setup Menu Contents” on page 69.
2.
Set the COUNTER switch to TC or UB.
n
To set the time: Set the switch to TC.
The time (Hour, Min., Sec.) is indicated on the counter
display. (24-hour clock system)
n
To set the date: Set the switch to UB.
The date (Month, Day, Year) is indicated on the counter
display.
3.
Press the HOLD button to enter the setting mode.
The “HOLD” indicator lights up on the display to indicate
that the unit is in the setting mode.
The leftmost digit on the counter blinks.
4.
Set the date and time.
• Each time the ADVANCE button is pressed, the value of
the blinking digit increases.
• Each time the SHIFT button is pressed, the digit to the
right of the currently blinking one starts blinking. When
pressed while the rightmost digit is blinking, the leftmost
digit starts blinking again.
Repeat the above procedure to set the value of all the
digits.
5.
To decide the set date and time data, press the PRESET
button.
The “HOLD” indicator on the display turns off and the date/
time display stops blinking.
The time starts counting.
To display and set the time code or user’s bit, set the VCR
Setup Menu item No. 516 DISPLAY SELECT to “TC”.
Memo: