JVC GY-DV500, Инструкция по эксплуатации

Страница: 18 / 96

18
2. CONTROLS, INDICATORS AND CONNECTORS
• The camera cannot be synchronized with a VCR
playback signal.
• When the power is switched ON while an external sync
signal is input, the screen moves in a vertical direction
for a few seconds. This is not a malfunction.
• Only for the combined H (horizontal)/V (vertical)
synchronizing signal. Synchronization with the SC (sub-
carrier) of the input signal is not possible.
Even if SC adjustment is performed, a phase shift will
take place at the time of power on/off. The SC phase
must be adjusted each time the power is turned on.
• If the external sync signal is disrupted during recording,
the “SYNC INH” (SYNC INHIBIT) indicator is displayed
on the counter display and recording stops.
• If the external sync signal is disrupted during playback,
playback of the disturbed video image continues.
Start playback again after synchronization is obtained
and the signal is stabilized.
[VTR REMOTE] connector
A part of the unit's functions can be controlled externally. To
remote control the unit using the control signal of this
connector, the VCR Setup Menu item No. 050 REMOTE
SELECT must be set to "RS232C".
For details, please consult your JVC dealer.
8
Microphone attachment holes
For attaching the microphone holder KA-A50 (optional).
☞
See "Attaching the Microphone (optional)" on page 32.
Note:
• When a cable is connected to the VTR REMOTE
connector, the VTR Setup Menu is not displayed in
the viewfinder. Make settings on the VTR Setup Menu
while the cable is not connected.
• When a cable is connected to the VTR REMOTE
connector, the VCR operation mode will not be
displayed correctly on the Status 1 screen in the
viewfinder.
VTR
REMOTE
SYNC IN
MIC IN
LENS
TEST OUT Y/C OUT MONITOR OUT LINE OUT
CH-1 CH-2
PUSH
DV CAMCORDER
GY-DV500
q
w
e
r
t
y
u
i
1
Cassette cover
Pressing the EJECT switch on top of the section opens this
cover so that a videocassette can be inserted or removed
from the unit. The cover can be locked automatically by
pushing and closing it.
* If the cassette cover is not closed, the GY-DV500 will
remain inoperative.
To prevent penetration of foreign objects into the unit,
do not leave the unit with the cassette cover open.
2
[MONITOR OUT] monitor output connector (BNC)
• Composite video signal output connector.
• Setup level signals are output.
An EE image or the playback image is output through the
VCR section.
An EE image is output during other modes than the
playback mode.
* Data for the Camera and VCR setup menus or time code
is not output.
• A setup level signal is not attached to the IEEE1394
signal’s EE image.
3
[Y/C OUT] connector (4P)
Separate YC video signal output connector.
4
[LINE OUT CH-1/CH-2] connector (RCA)
Output connector for audio signals.
• Outputs the input audio signal in the record and stop
modes.
• Outputs the playback audio signal in the playback mode.
• Alarm sound is not output.
5
[TEST OUT] connector (BNC)
Composite video signal output connector.
Outputs the camera image.
Setup level signals are output.
6
[SYNC.IN] connector (BNC)
For inputting the sync signal when the GY-DV500’s camera
image is synchronized with an external component.
2-3 Left Side Section
Memo:
Memo:
To prevent penetration of foreign objects into the unit,
do not leave the unit with the cassette cover open.