Masterpage:Right-No-Heading
EN
81
Filename [DR-M10SE_10Editing.fm]
Page 81
February 12, 2004 5:23 pm
Edit To Or From
Another Recorder
You can use your unit as the source player or as the
recording deck.
A
Make connections.
Connect the player’s 21-pin SCART connector to the
unit’s 21-pin SCART connector as illustrated.
A
When using your unit as the source player:
— connect its L-1 IN/OUT connector to the recording
deck.
B
When using your unit as the recording deck:
— connect its L-1 IN/OUT or L-2 IN/DECODER
connector to the source player.
●
If another recorder is compatible with the Y/C signal:
— when using your unit as the source player, set “L-1
OUTPUT” to “SCART S-VIDEO”. (
墌
pg. 82, “L-1 Output and
L-1 Input Setting (L-1 OUTPUT and L-1 INPUT)”)
— when using your unit as the recording deck, set “L-2
SELECT” to “S-VIDEO”. (
墌
pg. 83, “L-2 Select Setting
(L-2 SELECT)”)
B
Set the input mode of recording deck.
With this unit, press
PR +/–
to select “L-1” for the L-1 IN/
OUT connector, or “L-2” for the L-2 IN/DECODER
connector, depending on the connector being used.
●
When using another recorder as the recording deck, refer to its
instruction manual.
●
When using the L-2 IN/DECODER connector, set “L-2
SELECT” to “VIDEO” or “S-VIDEO”. (
墌
pg. 83, “L-2 Select
Setting (L-2 SELECT)”)
C
Set the recording speed.
Press
REC MODE
repeatedly until the desired recording
speed appears.
D
Start the source player.
Engage the Play mode of the source player.
E
Start the recording deck.
Engage the Record mode of the recording deck.
F
Stop dubbing.
Stop recording on the recording deck, then stop playback
on the source player.
NOTES:
●
All necessary cables can be obtained from your dealer.
●
For Y/C signal input/output, be sure to use a 21-pin SCART
cable that is compatible with the Y/C signal.
●
When you use this unit as the source player for editing, be sure
to set “SUPERIMPOSE” to “OFF” before starting. (
墌
pg. 95)
●
If you are using another recorder with S-Video and Audio
output connectors, connect its S-Video and Audio output
connectors to this unit’s S-VIDEO and AUDIO input
connectors on the front panel. Then, set the unit’s input mode
to “F-1” in step
B
, and set “F-1 INPUT” to “S-VIDEO”.
(
墌
pg. 83, “F-1 Input Setting (F-1 INPUT)”)
21-pin SCART cable
(provided)
Recorder
Your unit
Another recorder
Player
TV receiver
21-pin SCART cable
(not provided)
Recorder
Your unit
Another recorder
Player
TV receiver
21-pin SCART cable
(not provided)
21-pin SCART
cable
(provided)
Slide the
TV/CABLE/SAT/DVD
switch to
DVD
.
DR-M10SE_01.book Page 81 Thursday, February 12, 2004 9:08 PM