JVC D-ILA LD-HD2KBE, Инструкция по эксплуатации

Страница: 11 / 72

11
G
[DVI INPUT] Terminal
Signals that can be input are 480i/480p, 576i/576p
and 720p/1080i, 50 Hz/60 Hz signals. For passing
through when signals with scan rates as high as
though output from computers have been input. This
unit monitors the DVI input and output statuses at all
times and displays the corresponding information on
the LCD.
A
DVI
B
Upon input of compatible signals
A
NO INPUT
B
When there is no input signal
A
VERIFYING OUT-LINK
B
When there is an interruption in the DVI connection
with the projector
A
DVI PASS-THROUGH
B
When signals with scan rates as high as though
output from computers are detected and then output
without conversion
A
RATE NOT SUPPORTED
B
When signals not supported by this unit are detected
while analog RGB or YPrPb output is selected
●
It may take a while to display the screen upon input of
a HDCP signal.
●
In the Setup menu, set the DVI input level and type of
sync signal correctly. (
A
Page 23)
H
[IR LED] Terminal
Cannot be used with this processor.
I
[SCREEN] Terminal
For controlling the SCREEN TRIGGER-compatible
elevating screen. Set
A
SET: SCREEN TRIGGER
B
in
the Setup menu to
A
ON
B
, or set using the RS-232C
command. Output DC +12 V/100 mA when the power
of this unit is turned On.
●
Please read the
A
Precautions for using the screen
terminal
B
on Page 3 before use.
J
[DVI OUTPUT] Terminal
This is the DVI output terminal.
Use the DVI cable supplied with this unit to connect
with the projector.
●
It may take a while to project the images upon input of
a HDCP signal to this unit.
●
Set
A
SET: ACTIVE OUTPUT
B
of the Setup menu to
A
ANALOG RGB+DVI
B
or
A
DVI
B
. (
A
Page 22)
K
[RS-232 OPTION] Terminal (D-sub 9 Pin)
Cannot be used with this processor.
L
[RS-232 CONTROL] Terminal (D-sub 9 Pin)
This is compliant with the RS-232C interface
specifications. This unit can be controlled by a
computer connected externally. For details, please
consult your authorized dealer.
●
Set the
A
SET: RS232 ECHO
B
and
A
SET: BAUD
RATE
B
items in the Setup menu. (
A
Page 24)
M
Exhaust Fan
Expels warm air to keep the system cool.
Do not block the exhaust fan. This may cause the unit
to malfunction.
N
AC Power Input Terminal
This is the AC power input terminal. Connect the
supplied cord to this terminal.
ENGLISH
LD-HD2KU_E.book Page 11 Thursday, November 17, 2005 4:27 PM