8
Connecting Other Equipment
You can connect an external audio component used only as a
playback device.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all connections
are complete.
To connect an external audio component
Be sure that the plugs of the audio cords are colored: White
plugs and jacks are for left audio signals, and red ones for
right audio signals.
To play external audio component through this unit,
connect between the audio output jacks on the other
equipment and AUX jacks by using an audio cord (not
supplied).
Now, you can plug the AC power cord.
IMPORTANT:
Be sure to check that all connections are
done before plugging the AC power cord into a wall outlet.
Audio equipment
To audio output
Canceling the Demonstration
When connecting the AC power cord to a wall outlet, the unit
automatically starts demonstration.
To cancel the demonstration,
press and hold
CANCEL/DEMO until “DEMO OFF” appears
on the display.
• To cancel only beep sounds during the
demonstration, press and hold BEEP for more
than 2 seconds or press BEEP ON/OFF on the
remote control.
The BEEP ON indicator goes off from the
display.
When you press other buttons
The demonstration stops temporarily. It will start automatically
again (if no operation is done for 2 minutes) unless you cancel it by
pressing CANCEL/DEMO.
To start demonstration manually
Press and hold CANCEL/DEMO again until “DEMO START”
appears on the display.
BEEP
ON/OFF
FADE
MUTING
CANCEL
/DEMO
T
U
N
IN
G
/BEEP
EN01-08.HX-Z10&30[J]1
03.1.17, 11:02 AM
8