7
1
If the cords are covered with insulation,
remove a short section of insulation at the
end of each cord by twisting and pulling it
off.
2
Press and hold the clamp of the AM LOOP
terminals on the rear of the unit.
3
Insert the AM loop antenna to the AM LOOP
terminals as illustrated.
4
Release your finger from the clamp.
5
Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other terminals
and connecting cords.
• Keep the antennas away from metallic parts of the unit, connecting
cords, and the AC power cord.
AM antenna
Vinyl-covered wire
(not supplied)
AM loop antenna
(supplied)
1
5
Connecting Speakers
1
If the cords are covered with insulation,
remove a short section of insulation at the
end of each cord by twisting and pulling it
off.
2
Insert the end of the speaker cord into the
terminal as illustrated.
Match the same polarity: (+) to (+) and (–) to (–).
3
Close the speaker terminals.
IMPORTANT:
Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
• DO NOT connect more than one speaker to
each speaker terminal.
• DO NOT push or pull the speakers as this will
damage the foot spacers at the bottom of the
speakers.
2
3
Speaker cords
(black/blue)
Speaker cords
(black/blue)
Speaker cords
(black/red)
From right main
speaker terminal
From left main
speaker terminal
From right
subwoofer
terminal
From left
subwoofer
terminal
1
2
ANTENNA
AM EXT
AM
LOOP
FM 75
COAXIAL
3
4
EN01-08.HX-Z10&30[J]f
03.2.7, 3:30 PM
7
