JVC 0397MKV*UN*SN, Инструкция по эксплуатации

Страница: 38 / 68

38
EN
LIST OF ERROR MESSAGES
v
Appears when:
m
Action:
Message
COM port is not
available.
Connected device
not found.
Error — Transfer
halted.
v
Not connected to COM port set by JLIP Initialize.
m
Check the COM port number and connector and
retry JLIP initialization.
v
Connected devices are not turned on.
v
Selected COM port is not connected properly.
m
Make sure connection is proper and carry out JLIP
initialization. Then turn on this unit and the
connected devices.
v
Video unit is brought to STOP or ends playback
during automatic capture.
m
Check the auto capture setting.
v
Full image data (768 x 552 pixels) cannot be
captured if you start auto capture at the beginning
of the tape. Video capture stops if video playback
is stopped.
m
Start video capture 20 seconds after the start of the
recording.
v
Tape is too short to match the preset number of
images or there is a section of non-recorded tape.
m
Click "OK", check the tape length and re-enter the
number of images to be captured. Use a fully
recorded tape.
18
18,19
—
28
Page