Building-in features
This dishwasher is designed to be fitted under a
kitchen counter or sink.
In either case, it is essential that the recess dimen-
sions indicated in the picture are followed.
No further openings for venting of the dishwasher are
required, but only to let the water inlet and drain
hoses and power supply cable pass through.
The recess height may be anywhere between 820
and 880 mm from the floor since the dishwasher in-
corporates levelling feet adjustable over a wide range
(max 60 mm).
Adjust the height of the appliance by turning these
feet.
A distance of 2 mm should be allowed between the
top of the dishwasher and the counter top.
Fitting under a counter
(kitchen worktop or sink)
It is absolutely essential that the dishwasher is discon-
nected from the electricity supply before gaining access
to any internal component.
Fit the dishwasher into the appropriate housing space
and connect it. Make sure that the water fill and drain
hoses and the power supply cable are not bent or
kinked.
Fitting the panel to the door
The door which comes with this model is designed for the
overlay of a panel having the following dimensions:
Width:
446 mm
Height:
594 mm
Thickness:
20 mm max
Weight:
1.5 to 6 kg max
Note: The panel height should not be more than that
indicated, otherwise complete opening of the door will
no longer be possible as the panel hits against the
dishwasher plinth.
Furthermore, it is possible to fine up the control panel to
correspond with the height of the drawers of the
adjacent pieces of furniture, thus perfectly co-ordinating
with the style of the rest of the unit furniture in your
kitchen.
Add one or more of the
fillets provided until you
reach the desired height.
Secure the fillets as shown
in the picture, by means of
two screws 4,2 x 38 provid-
ed therewith.
Prepare the panel as follows:
Measure the distance (B)
between the part below the
control panel (or fillets) and
the reference notch (X) on
the door.
Measure the same distance
(B) on the wooden panel
starting from the upper edge.
At this distance position the supporting cross-bar provided,
in correspondence with the reference (Z). Keep the same
distance between the centre of the support's fastening
holes and the lateral edges of the wooden panel.
On the panel sign the seats for the four fastening
screws. Drill the panel with a Ø 2 x 12 bit and fix the
supporting cross-bar onto the wooden panel with the
3,5 x 16 screws provided.
Mount the decor panel by inserting the two pivots of
the cross-bar into the slotted holes of the door.
Lift the decor panel until the perfect alignment with the
facia panel is obtained.
BUILDING-IN
PII11GB
56
818
÷
878
450
820
÷
880
446
550
570
max.
max.
II45
0
÷
60mm
II06
II04
A
A
B
Z
X
=
=
550
B
2
1
II22
ENGLISH
