Juniper TCX1000-RDM20, Руководство по оборудованию

Страница: 79 / 206

1.
Attach the ESD grounding strap to your bare wrist and to a site ESD point.
NOTE: Place the rack in its permanent location, allowing adequate
clearance for airflow and maintenance, and secure it to the building
structure. If you are mounting multiple units in the rack, mount the heaviest
unit at the bottom and mount the others from bottom to top in order of
decreasing weight. The TCX1000-RDM20 weighs 12.92 lb (5.86 kg).
2.
Unscrew the 19-in. rear brackets from the chassis and set them aside, saving the
screws.
3.
Position the TCX1000-RDM20 so the FRUs are next to the hot aisle.
4.
Have one person grasp both sides of the chassis, lift it, and position it in the rack so
that the front bracket is aligned with the rack holes.
5.
Have a second person secure the front of the chassis to the rack using four mounting
screws (and cage nuts and washers if your rack requires them.) Tighten the screws.
See
Figure 19 on page 65 .
Figure 19: Installing the TCX1000-RDM20 on a Rack
6.
Continue to support the chassis while sliding the rear brackets into the channel of the
side-mounting rails and securing the brackets to the rack. Use the four mounting
screws (and cage nuts and washers if your rack requires them) to attach each bracket
to the rack. Tighten the screws.
NOTE: The rear bracket is long enough to allow for various bracket depths.
7.
Ensure that the chassis is level by verifying that all the screws on the front of the rack
are aligned with the screws at the back of the rack.
65 Copyright © 2019, Juniper Networks, Inc.
Chapter 11: Unpacking and Mounting the TCX1000-RDM20