Juniper TCX1000-RDM20, Руководство по оборудованию

Страница: 80 / 206

8.
Secure the rear bracket to the chassis using the saved screws from Step 2 .
9.
Install the fiber management clip on the front of the chassis, on the right or left hand
side, as required. See
Figure 20 on page 66 .
Figure 20: Installing the Fiber Management Clip on the TCX1000-RDM20
To mount the TCX1000-RDM20 on two posts in a rack using the 19-in. mounting brackets,
follow these steps:
1.
Attach the ESD grounding strap to your bare wrist and to a site ESD point.
NOTE: Place the rack in its permanent location, allowing adequate
clearance for airflow and maintenance, and secure it to the building
structure. If you are mounting multiple units in the rack, mount the heaviest
unit at the bottom and mount the others from bottom to top in order of
decreasing weight. The TCX1000-RDM20 weighs 12.92 lb (5.86 kg).
2.
Unscrew the 19-in. front and rear brackets from the chassis and set them aside, saving
the screws..
3.
Position the TCX1000-RDM20 so the FRUs are next to the hot aisle.
4.
Slide the front brackets into the channel of the mounting rails.
5.
Have one person grasp both sides of the chassis, lift it, and position it in the rack so
that the front bracket is aligned with the rack holes. See
Figure 21 on page 67 .
6.
Have a second person secure the front of the chassis to the rack using four mounting
screws (and cage nuts and washers if your rack requires them.) Tighten the screws.
Copyright © 2019, Juniper Networks, Inc. 66
TCX1000 Programmable ROADM Hardware Guide