JunosE 11.0.2 Release Notes
66
Errata
Use the
ip-router-name
command in Domain Map Configuration mode to
assign an IPv4 virtual router. The
no
version restores the default router. An
example of the
ip-router-name
command is as follows:
host1(config)#
aaa domain-map xyz.com
host1(config-domain-map)#
ip-router-name ipv4vr
JunosE Broadband Access Configuration Guide
,
Chapter 2, Monitoring and
Troubleshooting Remote Access
, fails to include the following information for the
output of the
show radius servers
command:
If a RADIUS server was never configured on the virtual router, the command
displays the following message:
host1#
show radius servers
no radius servers configured
If a RADIUS server was configured previously and then removed on the virtual
router, the command displays the following information:
host1#
show radius servers
RADIUS Authentication Configuration
-----------------------------------
Monitoring RADIUS Server Information ¦ 1
Udp Retry Maximum Dead
IP Address Port Count Timeout Sessions Time Secret Status
------------- ---- ----- ------- -------- ---- ------ ------
RADIUS Accounting Configuration
-------------------------------
Udp Retry Maximum Dead
IP Address Port Count Timeout Sessions Time Secret Status
------------- ---- ----- ------- -------- ---- ------ ------
RADIUS Pre-Authentication Configuration
---------------------------------------
Udp Retry Maximum Dead
IP Address Port Count Timeout Sessions Time Secret Status
------------- ---- ----- ------- -------- ---- ------ ------
RADIUS Route-Download Configuration
-----------------------------------
Udp Retry Maximum Dead
IP Address Port Count Timeout Sessions Time Secret Status
------------- ---- ----- ------- -------- ---- ------ ------
In the JunosE documentation for Release 9.3.x, 10.x.x, and 11.0.x, the
descriptions about support for DSL line rate information retrieval from access
nodes for transmission to the SRC software, and the
sscc
update-policy-request enable
command introduced by this feature are
erroneously omitted. This feature was introduced in JunosE Release 9.3.0.
NOTE:
The
ip-router-name
command replaces the
router-name
command,
which has been deprecated and may be removed completely in a future release.
