Errata
61
Release 11.0.2
In the
Change in existing behavior
section
of the
System
category in the
Release
Highlights
section of the
JunosE 11.0.0 Release Notes,
the term "our" in the last
sentence is misspelled. It is now corrected to read as "your".
The
Resolved
Known Problems
section of the
JunosE 10.2.2 Release Notes
failed
to mention in the
IP
section that defect ID 90081, High CPU utilization, was
fixed in that release.
The
Environmental Requirements
and
Cabling Recommendations
sections in
Appendix B, Installation Guidelines and Requirements,
of the
E120 and E320
Hardware Guide
fail to mention that, based on the optical fiber cables used, you
may need to increase the physical space provided for the chassis. The strain
relief and bend radius requirements of the optical fiber cables may exceed the
specified depth of the chassis and the cable-management bracket.
ERX Module Guide, Appendix A, Module Protocol Support
incorrectly states that
IPv6 multicast is supported on the following line modules:
cOCx FO line module with cOC3/STM1 modules
cOCx FO line module with cOC12/STM4 FO I/O modules
COCx-F3 line modules with CT3/T3 12 I/O modules
OCx/STMx ATM line modules with 4xDS3 ATM I/O modules
CT3/T3-FO line modules with CT3/T3 12 I/O modules
ERX Module Guide, Appendix C, Module Name Cross-Reference Information
fails
to include all ERX routers listed in the E Series Broadband Services Routers
datasheet dated December 2009. See
Appendix B, Module Name Cross-Reference
Information,
in the
JunosE 11.0.1 Release Notes
for a single table that lists the
module label name, software display name, and the model number for each
module for all ERX routers listed in the datasheet.
E120 and E320 Module Guide, Appendix A, IOA Protocol Support
incorrectly
states that IPv6 multicast is supported on the ES2-S1 Service IOA module. IPv6
multicast is not supported on this module.
The following chapters in the
JunosE System Basics Configuration Guide
contain
erroneous references about accessing the software image from the set of
JunosE Software CDs:
Chapter 3, Installing JunosE Software
Chapter 4, Configuring SNMP
Chapter 5, Managing the System
Beginning with JunosE Software Release 11.0.0, we are no longer providing a
set of software CD-ROMs nor can you order software CDs. You can create your
own software discs by downloading the compressed image bundle from the
Download Software page on the Juniper Networks website at
https://www.juniper.net/customers/csc/software.