Juniper JSA3500, Руководство по оборудованию

Страница: 122 / 154

3.
Tighten the side-rail screws. Insert the two small screws in the recessed holes on the
front rails and tighten.
4.
Slide the rear-mount rail brackets into the backs of the front rails on either side of the
chassis and align with your rear equipment rack posts. Secure the rear-mount rail
brackets to your equipment rack with two rack mount screws each. See
Figure 21 on page 106 .
Figure 21: Front-Rear-Mounting Recessed in Rack
g040408
Mounting bracket, positioned forward for recessed mounting.
5.
Insert locking screws on the sides of the rear-mount brackets to secure the front and
rear mounting brackets in place.
6.
Verify that the mounting screws on one side of the rack are aligned with the mounting
screws on the opposite side and that the appliance is level.
The recessed position allows network and console cables to be routed through the sides
of the equipment rack and through the holes of the recessed front rails on either side of
the unit. This enables easy cable routing on the racks with limited cable management.
Related
Documentation
Rack-Mount Installation Overview on page 89
•
•
Front-and-Rear-Mounting the JSA Appliance Flush to a Rack on page 104
•
Mid-Mounting the JSA Appliance in a Two-Post Rack on page 109
•
Required Tools and Parts for Installing the JSA Appliance on page 89
Front-and-Rear-Mounting the JSA7500 in a 4-Post Sliding Rail Rack
This option is used for the chassis that can easily pulled out from the rack when mounted
on the rack-mount system. The JSA7500 appliance is mounted using this option because
of the fan door available on the top of the appliance.
NOTE: The front-to-back rail spacing must be at least 48.3 cm (19-in.) from
the outside face of the front rail to the outside face of the back rail.
Copyright © 2018, Juniper Networks, Inc. 106
Juniper Secure Analytics Hardware Guide