Juniper JSA3500, Руководство по оборудованию

Страница: 127 / 154

Figure 28: JSA1500 with the CNA Card Inserted
6— 1— USB port Empty
7— 2— Console port Hard drive
8— 3— Fault LED IOC expansion slot with 2-port 10G CNA
module installed
9— 4— Hard disk activity LED IOC expansion slot
10— 5— Power LED Network ports
4.
Power on the JSA1500 unit and watch it boot on the serial console.
5.
Verify that the link and activity LED on the new 2-port 10G CNA module light up when
you connect the ports to your Ethernet switch with a duplex multi mode LC/LC MMF
fiber optic cable.
6.
Log in to the admin console. You should now see four more Ethernet interfaces appear
as 2-5. The four ports are labeled 0, 1, 2, and 3 and should map to Ethernet interfaces
as follows (default in Linux):
• 0 = eth0
• 1 = eth1
•
2 = eth2
•
3 = eth3
Related
Documentation
•
Connecting to a Management Device on page 100
•
Grounding the JSA7500 Appliance on page 97
•
Connecting JSA to a DC Power Source on page 98
•
Installing the JSA Hardware on page 103
•
Chassis Console Port Pinouts on page 9
111 Copyright © 2018, Juniper Networks, Inc.
Chapter 17: Installing the JSA Appliance