Juniper JSA3500, Руководство по оборудованию

Страница: 120 / 154

If your JSA appliance contains two power supplies, plug each power cord into a
separate power circuit to ensure that the device continues to receive power if one of
the power circuits fails.
4.
Plug the Ethernet cable into the port labeled
0
on the front panel. See
Figure 19 on page 104 .
When you turn on the power, the internal port uses two LEDs to indicate the LAN
connection status.
Figure 19: JSA1500 Front Panel
JSA1500
6— 1— Console port Empty
7— 2— Hardware LED Hard drive
8— 3— Hard disk activity LED IOC expansion slot
9— 4— Power LED Network ports
5—USB port
5.
Plug straight-through or crossover cable into the console port. This cable is shipped
with your JSA appliance. It is a console cable and DB-9 connector with 1-8 pinouts.
6.
Push the power button on the back panel.
The green LED below the power button turns on. The JSA hard disk LED turns on
whenever the appliance reads data from or writes data to the JSA hard disk.
Related
Documentation
Connecting to a Management Device on page 100
•
•
Installing the CNA Module on the JSA1500 Appliance on page 110
•
Grounding the JSA7500 Appliance on page 97
•
Connecting JSA to a DC Power Source on page 98
•
Chassis Console Port Pinouts on page 9
Front-and-Rear-Mounting the JSA Appliance Flush to a Rack
This option is used for larger chassis that require additional support when mounted on
the rack-mount system. The JSA5500 appliance use this mounting option as its default
configuration.
Copyright © 2018, Juniper Networks, Inc. 104
Juniper Secure Analytics Hardware Guide