Juniper BT8A78CH1, Обзор оборудования и руководство по установке

Страница: 126 / 228

You should install the BIC into a UFM that is already installed in a chassis. An installed
UFM provides stability as you slide the BIC into the BIC slot. Otherwise you run the risk
of damaging components on the BIC if there is movement when sliding it into the BIC
slot.
Tools Required
•
Number 2 Phillips screwdriver
NOTE: Be familiar with the site, safety, and installation guidelines described
in “Module Installation and Removal Guidelines” on page 108 .
1.
Locate the UFM in which you want to install the BIC and move aside any fibers blocking
access.
Remove the BIC filler panel if installed.
2.
Take the BIC out of its antistatic bag, holding it by its edges and faceplate to prevent
damage to the module circuitry. Save the bag for future use.
3.
Install the module.
a. Ensure that the bottom latch is in the open position. See “BIC Handles and Latches”
on page 125 .
b. Position the module.
•
BTI7814
: Position the module vertically so that the faceplate is toward you and
the latch is at the bottom.
• BTI7801 , BTI7802 : Position the module horizontally so that the faceplate is toward
you and the latch is on the right.
c. Align the module with the slot guides.
d. Hold the module by the top handle and bottom latch and insert the module edges
in the slot guides. The module should slide in smoothly.
Carefully slide the module until it contacts the UFM connector and push on the
faceplate firmly until the module is seated.
e. Close the bottom latch by pushing the latch straight in.
4.
Carefully tighten the faceplate thumbscrew. Use a screwdriver if necessary.
You have successfully completed this procedure.
Removing a BIC
Use this procedure to remove a BTI Interface Card (BIC) from a UFM.
This procedure is the same for all BIC types.
Copyright © 2019, Juniper Networks, Inc. 126
BTI7800 Series Hardware Overview and Installation Guide