JUNIOR JONES J-SPIRIT, Инструкция по эксплуатации

Страница: 6 / 14

J-SPIRIT Instruction Manual
J-SPIRIT Instruction Manual
20 21
1. Fitting/removing the rear wheels
Press the button in the centre of the rear wheel, align the axel and push
onto the rear wheel housing (fig. 1).
Important: Check the wheels are correctly fitted before use.
To remove the rear wheels, press the button in the centre of the rear
wheel and pull the wheel away from the wheel housing.
2. Unfolding the J-SPIRIT
Release the wheels from their lugs (fig. 2 & 3) and push forward until
the chassis base locks into place (fig. 4).
Unclip the travel lock located at the rear wheel (fig. 5).
Lift the handle bar upwards (fig. 6) until it locks into place (fig. 7).
Lift the seat unit upwards into an upright position (fig. 8 & 9) and then
drop the seat section downwards into place (fig. 10). Unfold the hood
by pulling it forwards (fig. 11).
WARNING
: ensure the locking devices are engaged before use.
3. Adjusting the handle height
Twist the barrel on the handle forward and move the handle upwards
until it is in the desired position (fig. 12).
When folding the J-SPIRIT always ensure that the handle is in the
lowest position.
4. Using the front swivel wheels
The front wheels can be in a fixed forward travelling position or swivel
position.
Rotate the switch located above the front wheel to lock the wheels in a
forward travelling position and twist again to change back into swivel
mode (fig. 13).
For uneven surfaces you may find the stroller is easier to manoeuvre in
the fixed forward position.
5. Operating the parking brake
Press down on the pedal to engage the parking brake (fig. 14).
Press down again to release the brake.
WARNING
: never leave your stroller without fully engaging the
parking brake.
6. Attaching/removing the bumper bar
Insert the bumper bar into the housings on both sides of the seat unit (fig. 15).
Press the buttons on either side of the bumper bar to release (fig. 16).