2.
Brand new system nozzles don't spray
Whatever happens, please do not try to "fix" the nozzle tips. We test them twice
before shipping them out and these work just fine. Before doing anything to the
misting assembly or the nozzle tip, correct your system setup, pump position,
bulkhead install and test the system.
NOTE:
You cannot blow through the nozzle
as they contain a check valve. Even if you could blow through it, the flow would be
so low that you would not feel it. Pumps work at high pressure and open the check
valve.
3.
Nozzles used to spray better, what happened? It worked before!
always ensure that the bulkhead is installed and that the pump is gravity fed.
Never install the pump above the reservoir.
keep the reservoir clean. You may have dust, debris falling into the reservoir
making the clean water dirty
Use only Reverse Osmosis or demineralized water. Using tap water or water
filtered though a small kitchen filter will still have minerals present which will
eventually distort the misting pattern or clog the super fine opening in the nozzle.
Never tamper with the center of the nozzle tip as that will for sure damage it,
instead soak the whole assembly in CLR or vinegar solution to dissolve the
