Jungheinrich ECR 327, Руководство по эксплуатации

Страница: 82 / 225

E 45
0705.USA
8 Troubleshooting
This section is designed to help users to identify and rectify simple faults or the
consequences of operator errors themselves. When trying to locate faults, you should
follow the sequence of actions shown in the table.
NOTICE If the "remedies" above did not help to rectify the fault, please contact the
manufacturer's service organization, since further fault correction can only be
carried out by qualified service personnel.
Fault Possible cause Remedy
Vehicle will
not move – Battery connector not
plugged in
– Check battery connector and plug in if
necessary
– Battery holder not fitted
(
o
)
– Fit battery holder
– Switch latch in
position "0"
– Turn switch latch to position "I"
– Battery charge
too low
– Check battery charge, recharge
battery if necessary
– Faulty fuse – Check fuses
Load cannot
be raised – Vehicle not
ready for use
– Work through all the remedies listed
under "Vehicle will not move"
– Hydraulic oil level too
low
– Check hydraulic oil level
– Load too heavy – Check maximum load capacity
(see nameplate)
– Battery charge monitor
has switched off and
indicates "STOP"
(CANDIS,
o
)
– Charge battery
– LED on discharge
indicator lights up yellow
(LEA,
t
)
– Charge battery
– Coast LED lights up
yellow
– Charge battery
– Faulty fuse – Check fuse 2F1
No display on
battery
discharge
indicator – Vehicle not
ready for use
– Check battery connector and plug in if
necessary
– Faulty fuse – Check fuse 6F1