Jungheinrich ECR 327, Руководство по эксплуатации

Страница: 78 / 225

E 41
0705.USA
5.5 Travel parameters
NOTICE On vehicles without an information display (CANDIS (
o
)), travel parameters
can only be set by the manufacturer's service organization.
The example below shows how to change the acceleration parameter setting for
travel program 1 (parameter 101).
Acceleration
– Enter the three-digit parameter number (101) and press the Set key (23) to confirm.
– Check the LCD display on the information display (CANDIS (
o
)) (parameter
number and current parameter setting are displayed).
NOTICE If nothing is entered for around 5 seconds, the display switches back to the
operating hours display.
NOTICE If the parameter number displayed is not the one you require, you must wait
until the display changes back to the operating hours display.
– Enter or change the parameter value as shown in the parameter list.
– Check the LCD display on the information display (CANDIS (
o
)) and press the
Set key (23) to confirm.
– The LED (22) in the
o
key (27) lights up briefly and after about 2 seconds starts to
flash again.
NOTICE If an illegal value is entered, the LED (22) in the
o
key (27) flashes red. Enter
the parameter number again and then enter or change the setting.
To enter additional parameter settings, wait for the LED (22) in the
o
key (27) to start
flashing and then repeat the process. When you have finished, press the
o
key (27).
Information display
(CANDIS)
LED (27)
o
key
LED (24)
Key 1
LED (25)
Key 2
LED (26)
Key 3
Current
setting
is displayed
101 6
green
flashing
out out out
New
setting
is displayed
101 8
green
flashing
out out out
Parameter
number
Paramete
r setting