digital audio
modular
processing system
C8000
64ch BNC MADI & AoIP I/O
C8315
9/20
DANTE INTERFACE
Product Type
[c8k_x]
Customized version for the c8k system
Product Version
[x.y.z]
HW of the DANTE OEM module
Module
[Brooklin II]
DANTE OEM module
Module Software
[3.10.0]
Software version of the module FPGA
Module MB App
[1.1.5]
Software version of the FPGA embedded controller
RESET
Restart Module
<RESTART>
Pressing the soft button
will warm start the module.
Initialize and Restore
<INITIALIZE>
Factory Defaults
Pressing the soft button,
will clear the parameter memory and
will initialize all parameters to their factory default values.
BACKUP / RESTORE
Backup Settings and
<BACKUP>
Presets to File
Pressing the soft button will create an XML file that one may
store on a PC.
Restore Settings and
<RESTORE>
l
Presets from File
Pressing the soft button will upload a backup file that has been
selected via soft button
<BROWSE>
and move the previously
stored settings back to the module.
SETUP:
Set up of general device parameters
Common Config
Enable Bus Driver
[ON/OFF]
You can temporarily disable the bus drivers by selecting OFF here.
The state of this soft switch also depends on the setting of
SW1
on
the module PCB.
If
SW1 #1
is turned off, this switch will be off after a power cycle.
You can turn it on temporarily to check out your settings but you
must keep in mind that after the next power cycle it will be off again
unless you have turned
SW1 #1
on.
This procedure is useful if you must insert a module into a frame
that is on air and other services must not be interrupted or
disturbed.
