o
Within 10 seconds. start a connection process on a transmitter from the existing network
(see chapter 4.2 or the manual of the respective transmitter).
i
After 10 seconds, if no connection process is started, the transmitter will search an open
network in order to join it.
LEDs light up green for 3 seconds. Transmitter has been added to a network.
LEDs flash red quickly for 10 seconds. Transmitter has not been added to a network.
4.4 Cloning the transmitter
All connections of a transmitter will be transferred to another transmitter. This function can only
be used with our transmitters.
o
Add a new transmitter to the network, see chapter 4.3.
Figure 12
Precondition:
At least one luminaire must be switched on.
o
Press the
Ƌ
and
ƍ
buttons on the new transmitter simultaneously until the LEDs
flash green.
The new transmitter is in programming mode.
o
Within 10 seconds, start a connection process on the transmitter to be cloned, see
chapter 4.2.
LEDs light up green for 3 seconds. The new transmitter has accepted the connection.
LEDs flash red quickly for 10 seconds. The new transmitter has not accepted a connection.
4.5 Resetting a luminaire
All connections of the luminaire will be disconnected and the allocation to a network will be
deleted.
i
If several luminaires are mounted near to each other, it might be necessary to disconnect
those luminaires from the mains that are not supposed to be reset.
9/17
32596203
J0082596203
23.05.2016
ZigBee radio transmitter module 4-gang
