5.2 Commissioning
Teaching the presence detector in the radio detector
The presence detector may be taught in only one receiver for light control. The teaching
procedure only results in an assignment in the receiver.
When a presence detector is taught-in the sensitivity of the receiver is reduced to approx. 5 m.
The distance between the receiver and the presence detector being taught should therefore be
between 0.5 m and 5 m.
A radio presence detector does not work together with a radio motion detector. For this reason
no radio motion detector may be taught in the corresponding receiver, and may have to be
deleted. Otherwise it is not possible to teach in the presence detector and the radio receiver
remains in programming mode.
Figure 9: Brightness adjuster
When teaching the first presence detector in the receiver the brightness adjuster (7) must not
point to the Moon symbol (figure 9). A presence detector that is set this way cannot be the first
taught in a receiver.
i
In the state as delivered the adjuster points to the Sun symbol.
i
It is possible to teach additional presence detectors in the radio receiver (see Presence
detector system chapter).
o
Take batteries out of the presence detector for approx. 2 minutes.
o
Switch receiver to programming mode (see instructions for receiver).
o
Put batteries back into the presence detector.
The presence detector transmits teaching telegrams for approx. 30 seconds. The receiver
acknowledges the teaching procedure (see instructions for the receiver).
o
Switch receiver back to operating mode (see instructions for receiver).
The presence detector has now been taught in the radio receiver.
Setting sensitivity, run-on time and brightness setpoint
The brightness actual value measured at the presence detector consists of the reflected
artificial light and daylight, and depends on the reflective characteristics of the surface under the
presence detector.
9/14
82536633
J0082536633
16.08.2016
Radio Management
Radio presence detector
