6.2 Troubleshooting
Lighting does not switch on.
Cause 1: sensitivity of the presence detector is set too low.
Increase sensitivity (see Commissioning chapter).
Cause 2: batteries in presence detector are empty.
Change batteries (see Fitting chapter).
Cause 3: Radio range exceeded.
Check the installation situation. Structural obstacles reduce the range.
Using a radio repeater.
Cause 4: ambient brightness is greater than the brightness setpoint.
Decrease brightness setpoint (see Commissioning chapter)
When a switch actuator is used: lighting switches on and off repeatedly - so-called "light
oscillation".
Cause: the brightness setpoint set on the presence detector is too low.
Increase brightness setpoint (see Commissioning chapter).
LED flashes approx. 10 times during a transmission.
Cause: batteries in presence detector are almost empty.
Change batteries (see Fitting chapter).
6.3 Conformity
Albrecht Jung GmbH & Co. KG hereby declares that the radio system type
Art. No. FPM360WW / FPM360AL
corresponds to the directive 2014/53/EU. You can find the full article number on the device. The
complete text of the EU Declaration of Conformity is available under the Internet address:
www.jung.de/ce
6.4 Warranty
The warranty follows about the specialty store in between the legal framework as provided for
by law.
ALBRECHT JUNG GMBH & CO. KG
Volmestraße 1
58579 Schalksmühle
GERMANY
Telefon: +49 2355 806-0
Telefax: +49 2355 806-204
[email protected]
www.jung.de
14/14
82536633
J0082536633
16.08.2016
Radio Management
Radio presence detector
