LB management
Motion and presence detector
–
Night light function
–
Constant light regulation
Automatic operation
The device detects heat motions of people, animals and objects.
–
The light is switched on if a person enters the detection field and the brightness threshold
is below the set brightness threshold.
–
The run-on time restarts with each detected motion.
–
The light is switched off, if:
no more movement is detected in the detection field and the run-on time has elapsed or
the ambient light is too bright and the run-on time has elapsed.
To avoid any switch-on caused by a cooling illuminant, no movement signals are evaluated for a
brief lockout time after switching off. The motion detector adjusts itself to the ambient conditions
to keep the time as short as possible.
Behaviour after a mains voltage failure
After mains voltage return, the device performs a self-test for a maximum of 20 seconds. After
the self-test has been completed, the device is ready for operation.
If the red status LED flashes three times at repeated intervals, the cover was previously
connected to another insert. To enable the function again, either place the cover onto the
respective insert or press the Bluetooth button (4) for longer than 4 seconds.
The following applies during the self-test:
–
The red status LED is illuminated.
–
The load is switched off.
–
Movements are not detected
–
The device can be operated via extensions
4
Commissioning
Install app on a mobile end device
Requirement for operation via app is a mobile end device with Bluetooth interface, running the
Android operating system or iOS.
￭
Download and install the Clever Config app from the iTunes App Store (iOS) or Google
Play Store (Android).
Couple mobile end devices via Bluetooth
Precondition: insert and cover must be ready for operation. The mobile end device is located
close to the cover.
￭
Activate coupling mode: Press the Bluetooth
Ʃ
button (4) (Figure 1) for more than 4
seconds.
The blue LED flashes. The coupling mode is active for one minute.
￭
Start the Bluetooth app and search for device to be coupled.
Cover is coupled with the end device and shown in the app.
The coupling mode is automatically exited after successful coupling. The blue LED lights
up to confirm an active connection.
A maximum of 8 mobile end devices can be coupled with a cover. When coupling the 9th
device, the oldest device will be deleted.
5
Operation
The app is used for the configuration and operation of the device. Some basic functions can
also be operated via connected extensions.
3 / 13
82599323
25.10.2019
J0082599323
