LB management
Universal timer Bluetooth
Parameters
Setting options
Default setting
Explanations
Maximum bright-
ness
75 ...100 %
Default setting: 100%
Specifies the maximum settable brightness.
Switch-on bright-
ness
1 ...100 %
Default setting: 100%
During brief operation, the output switches on
at the set switch-on brightness. Note: If the
value is above the set maximum brightness or
below the minimum brightness, then the sys-
tem will switch to the appropriate limit value.
Switching on to
the last value
On, Off
Default setting: Off
It is switched on to the brightness that existed
before switching off.
Settings only for 2-channel switch inserts
Parameters
Setting options
Default setting
Explanations
Dedicated fan
channel
On, Off
Default setting: On
Switches the switch-on delay for output 2 on
and off.
If the parameter is switched off, output 2
switches on simultaneously with output 1.
Switch-on delay
channel 2
0 s ... 60 min
Default setting: 2 min
After switching on output 1, output 2 also
switches on after the time set here has
elapsed.
Precondition: "Dedicated fan channel" para-
meter is switched on.
Switch-off delay
channel 2
0 s ... 60 min
Default setting: 5 min
After switching off output 1, output 2 also
switches off after the time set here has
elapsed.
Settings only for venetian blind inserts
Parameters
Setting options
Default setting
Explanations
Minimum motor
change-over-time
300 ms ... 10 s
Default setting: 1 s
Minimum interruption time when changing dir-
ections. Increasing the minimum change-over
time will cause less wear on the motors.
Blind/shutter run-
ning time
1 ... 600 s
Default setting: 120 s
Absolute time which the blind/shutter requires
from the top to the bottom end position. The
entry is essential if position movements are to
occur.
Slat change-over
time
300 ms ... 10 s
Default setting: 1 s (vene-
tian blind)
0.3 s (awning)
Absolute time for changing-over Venetian
blind slats. Here, the fabric-stretching time can
be set for the operation of awnings.
Inverse operation On, Off
Default setting: Off
Inverts the activation of the relay outputs. Dur-
ing inverted operation, the relay outputs "Up"
and "Down" should be activated in reverse.
This is required, for example, for controlling
skylights.
7 / 10
32598103
02.10.2019
J0082598103
