JUMO dTRANS T06, Руководство по эксплуатации

Страница: 70 / 112

7 Configuration
70
7.5.4 Scaling start Here, the output range set above is shown on the set
scaling of the signal type.
2 to 8 V is set in Chapter 5.4 "Signal flow"
4 to 20 mA,
(the full range of the signal
type above is applied per
default)
7.5.5 Scaling end
7.5.6 Reversion output The signal at the output can be inverted here, e.g. for a
setting of 0 °C = 0 V and 50 °C = 10 V,
through the reversion this becomes 50 °C = 0 V and
0 °C = 10 V at the output
No, Yes
7.5.7 Error signal If, for the measured value, the value is exceeded, not
reached, or a diagnostic error occurs, the current or
voltage value set on the analog output is output as a
so-called error signal. Negative signaling,
positive signaling,
replacement value
For signal type 4 to 20 mA Low 3.6 or high 21.2 mA
For signal type 0 to 20 mA Low -0.4 or high 21.2 mA
For signal type 2 to 10 V Low 1.8 or high 10.6 V
For signal type 0 to 10 V Low -0.2 or high 10.6 V
7.5.8 Response for limit error Here you can select whether the analog output should
also jump to the error value if the relay switches on "1"
due to a limit value being exceeded or fallen short of. No error signal,
error signal
7.5.9 Signal from diagnosis er-
ror Here you can select whether the device sets the output
to an error value for all detected errors, or whether only
device-relevant errors should be considered. This
selection option only exists if there is a relay. All errors,
device-relevant errors
k
SIL operation
Parameter Comment
Value range
(default setting in bold)