3
2
Safety
Before attempting to operate this floor/wall heater, the
following basic safety precautions should be taken to
reduce the risk of fire, electric shock and personal injury.
It is important to read the instruction manual and to
understand its’ applications, limitations and potential
hazards associated with this floor/wall heater. This
floor/wall heater is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning the use of the appliance by a person
responsible for their safety. This floor/wall heater is not
designed for use within 1m or above a water source. It
is important that you read, understand and follow these
instructions very carefully. They are designed for the safety
of yourself and others ensuring a long and trouble free
service life from your floor/wall heater. This electric floor/
wall heater complies with Australian and International
standards and safety requirements. Repairs should only be
carried out by qualified persons using original spare parts.
Failure to do so may result in considerable danger to the
operator.
Safe Operation
Beware of Children and Pets
Children should not be allowed to touch or operate floor/
wall heaters or touch extension cords, if used. All floor/
wall heaters should be kept out of reach of children,
preferably stored or locked in a secure cabinet or room
when not in use.
Do Not Abuse the Power Cord
Never yank or pull on the power cord to disconnect it
from the mains supply socket. Never carry your floor/wall
heater by its’ power cord. Keep the power cord away from
heat, oil, solvents and sharp edges. Check the power cord
regularly for any damage and if the power cord becomes
damaged have it replaced by an authorised service facility.
Extension Cords and Reels
This floor/wall heater is NOT designed to run off an
extension cord. If you require an additional power point
please have one installed by a qualified electrician.
The use of extension cords may cause power voltage loss
which will result in damage to the motor this will NOT be
covered under warranty.
Installation
Always ensure you select the correct fixing accessories
which suit the particular floor/wall material you are
attaching to, if in doubt please discuss with your local
retailer or local hardware store. This floor/wall heater is
not designed for use within 1m or above a water source.
All installations must meet the requirements of Australia
Standard AS/NZS 3000:2007.
Ensure that the floor/wall heater is not positioned directly
above or below a power point or switch.
This floor/wall heater is not designed to be used with 3rd
party timer or programmable system.
WARNING: Fire risk exists if this heater is covered by
or positioned close to curtains or other combustible
materials.
NOTE: If using this floor/wall heater outside ensure that it
is connected directly to an outdoor power point.
The electrical system of this floor/wall heater must be
connected with an automatic 30mA circuit breaker and/or
residual current device (RCD). If uncertain have a qualified
electrician check your electrical system before installation
and/or use.
All electrical connections are made in a dry area.
Outdoor power points must be weatherproof and installed
by a qualified electrician.
Sitro Group Australia Pty Ltd is not responsible for
incorrectly chosen fixing accessories or any damage which
may be caused by an incorrectly fitted floor/wall heater.
Installation, Operation
& Maintenance
