7
6
To Operate
NOTE: REMOTE CONTROL WILL ONLY OPERATE FROM
STANDBY MODE.
1. Plug into 240V AC wall socket and turn on.
2. Press the ‘
ON/OFF
’ switch on the back of the heater
head to on ‘
-
’. Blue light will flash indicating it is in
standby mode.
3. Press the ‘
ON
’ button on front panel or remote control
and the heater will start. The blue light is now on.
4. To turn heater off and leave on standby mode press
‘
OFF
’ button (use either control panel OR remote
control). Heater is now off and in standby mode. Blue
light flashes.
5. To turn heater off completely press ‘
ON/OFF
’ switch on
the back of the heater head to off ‘
O
’.
6. Turn off at wall socket and unplug.
Cleaning
Always ensure that the floor/wall heater has been left for
one (1) hour to cool before cleaning.
1. Turn off and disconnect from mains power, allow to
cool.
2. Wipe unit over with a damp clean soft lint free
cloth.
3. For stubborn marks you can use a mild dish washing
solution on a damp clean soft lint free cloth.
NEVER allow water or a mild dish washing solution to enter
or drip onto the floor/wall heater.
NEVER use solvents, e.g. Petrol, Toluene, Methylated Spirits
etc. to clean the heater, as these will damage the surface
finish and may cause a fire when unit is next used.
Operation & cleaning
SENSOR
ON
OFF
OFF
ON
Off
On
Side View
Front View
Remote
