Jula Meec tools 005876, Руководство по эксплуатации

Страница: 32 / 33

EN
32
CONNECTION TO POWER POINT
1. Make a loop in the extension cord.
FIG. 7
2. Put the loop through the hole on the back
of the top handle and hook it on the stress
reliever.
FIG. 8
3. Connect the extension cord to the snow
shovel. Secure the extension cord so that
it cannot come loose during the work.
FIG. 9
4. Plug the extension cord into a power
point.
STARTING AND STOPPING
1. To start the snow shovel press the safety
lock on the top handle with your thumb
and press the power switch with your
fingers. When the motor starts the safety
lock can be released without the motor
switching off.
2. Switch off the snow shovel by releasing
the power switch.
IMPORTANT:
Carefully inspect the area where the snow
shovel is to be used and remove any stones,
toys, or other foreign objects that can be
pulled into the snow screw and thrown out.
TIP
• Start the snow shovel and tilt it so that
the snow blade rests on the ground. Push
it forward. Adjust the speed to clear away
all the snow. The best speed depends on
the depth of snow and its weight.
• Direct the snow to the left or right by
putting the snow shovel at a slight angle.
• For the best results, throw the snow
downwind and run with overlapping
movements.
• If the snow is deep, hold the top and
bottom of the handle and work with
sweeping movements to remove the top
layer. Up to 15 cm of snow can be
removed in each sweep. Do several
sweeps to clear all the snow.
• Keep the power cord away from obstacles,
the snow screw and other sharp objects or
edges. Do not jerk the power cord and
avoid treading on it or running over it.
• Always switch off the snow shovel and pull
out the plug after use.
MAINTENANCE
WARNING!
• Switch off the snow shovel and pull out
the plug before cleaning and/or
maintenance. If the snow shovel is
unintentionally started while cleaning/
maintenance this can result in fatal or
serious personal injury, and/or material
damage.
• Only use parts and accessories
recommended by the manufacturer.
REPLACING THE SNOW SCREW
WARNING!
Switch off the snow shovel and pull out the
plug before starting.
1. Undo the five screws holding the right side
panel and remove the panel.
FIG. 10
2. Secure the snow screw and remove the
nut.
FIG. 11
3. Undo the five screws holding the left side
panel and remove the panel.
FIG. 12
4. Lift off the belt from the drive plate.
FIG. 13