Jula MarQuant 006072, Руководство по эксплуатации

Страница: 15 / 16

EN
15
5. Twist the catch 90° to the right to lock.
FIG. 6
USE
The foot file is only intended to be used to
remove calluses from the feet. Do not use it on
any other part of the body, or on damaged or
bleeding skin.
1. Wash your feet and wipe dry.
2. Fit the required roller as per the
instructions to change rollers under
Maintenance. Check that the roller is
correctly and firmly fitted.
3. Remove the cover from the roller.
4. Start the foot file by pressing the safety
catch in the middle of the power switch at
the same time as the switch is pushed up.
FIG. 7
5. Carefully move the roller back and
forwards over the callus with a circular
action for 2–3 seconds. Do not press too
hard, let the roller slide lightly over the
skin. The roller stops if the appliance is
pressed too hard against the skin. Stop
the appliance and check if the skin feels
sufficiently soft and smooth. If not, rub
for another 2–3 seconds and check again.
Continue until the skin feels soft.
FIG. 8
NOTE:
• Stop using the roller if the skin becomes
tender or inflamed.
• Do not allow the roller to be in contact
with your skin for more than 2–3
seconds at once.
6. Switch off the appliance.
FIG. 9
7. Wash the skin, or remove dead particles
of skin with a wet towel.
8. Clean the appliance as per the
instructions.
DESCRIPTION
The appliance can be used to remove dry,
rough skin and calluses from the feet. The
unique scrubber roller spins 40 turns per
second and the wide angle of 300° gently
and effectively removes calluses. For hygienic
reasons we recommend that every user uses
their own roller.
FOOT FILE PARTS
1. Cover
2. Roller
3. Lock button
4. Safety catch
5. Power switch
6. Battery cover
7. Catch for battery cover
8. Cleaning brush
FIG. 1
USE
INSERTING THE BATTERIES
1. Open the battery compartment by
twisting the catch for the battery cover
90° to the left until it clicks in place.
FIG. 2
2. Pull the cover down.
FIG. 3
3. Insert 2 alkaline AA batteries in the
battery compartment. Make sure to insert
the batteries with the correct polarity as
per the markings.
FIG. 4
4. Close the battery cover by pushing it in
place.
FIG. 5