EN
44
If the treadmill has moved to the right, tighten the screw on right
of the belt or release the screw on the left. Do in reverse order if
the belt has moved to the left.
THE BELT SLIPS
FIG. 22
Adjust the belt tension with the screws as shown in the diagram.
Make sure to turn the screws equally. We recommend turning the
screws one half turn. Check that the belt does not slip or move to
one side. Do not tension the belt too hard, this can damage it.
Use
Follow the instructions to change the settings.
1. Press ME down on the right.
2. Press Settings at the bottom and then Enable Control.
FIG. 19
View Only Supported Devices
• Only the affected exercise equipment is shown with
Bluetooth synchronising.
Enable Treadmill Control
• This means you can set the speed and resistance from the
mobile phone.
Allow History Deletion
• Allows you to delete exercising history.
After connecting four modes are shown in the app. Select the
required mode and press START to start exercising
FIG. 20
WARNING!
Be careful when using the app while exercising, it can be
distracting.
FIG. 21
When starting to exercise the data for time, calorie consumption,
distance, number of steps per minute, pulse, average speed and
average stepping frequency are shown. After exercising, press the
STOP button. FitShow saves the session in the exercise history.
MAINTENANCE
CLEANING
WARNING!
Switch off the equipment before cleaning.
Keep the belt, treadmill and foot plates free from dust –
accumulated dust increases belt friction, which can damage the
equipment. The equipment should be cleaned every month.
LUBRICATION
The machine must be lubricated at intervals of 300 km. An
audible signal is emitted every 10 seconds and OIL is shown on
the display when it is time to lubricate.
1. Apply lubricating oil under the belt in the middle of the deck
on each side.
2. Once lubricating is complete, press and hold the STOP
button for 3 seconds to remove the reminder.
THE BELT IS NOT CENTRED
After some time the treadmill can move to one side. Run the
equipment unloaded to see if the belt centres automatically. If
not, centre by turning the screws as shown in the diagrams below.
Содержание KAYOBA 002-400
