EN
25
Fountain pump with water nozzle
Fit the water nozzle (13) on the connection pipe (17). The closer the nozzle is to the water’s surface, the
larger the nozzle diameter that can be used. Adjust the nozzle as shown in figure 2. The nozzle’s water flow
and diameter can be adjusted.
For the water jet’s maximum diameter, refer to the table below.
Diameter for water nozzle, A
750 mm
Operation of the fountain pump and water nozzle
The water feature can be connected to the spray connection using a hose with a 13 or 19 mm inner
diameter.
Open the spray connection by turning the tap (11) 0–90° anti-clockwise, depending on the desired flow.
Operation using water nozzle only
Turn the tap anti-clockwise all the way to 90°. All the water will then flow through the spray connection
(12) and none will flow through the fountain.
MAINTENANCE
NOTE!
Unplug the fountain pump before carrying out servicing and maintenance.
Cleaning the sponge filter
As cleaning also eliminates necessary microorganisms, the fountain pump’s sponge filter should only be
cleaned when absolutely necessary. However, the filter must be cleaned as soon as the fountain pump’s
efficacy becomes noticeably impaired, or when the dust filter is no longer working satisfactorily.
1.
Press in the filter housing’s (1) sides and remove it from the pump body.
2.
Take the sponge filter (2) out of the filter housing and clean it with clean, cold water.
NOTE!
Never use the fountain pump without the sponge filter as this can damage the pump.
Cleaning mechanical parts
Only when visibly dirty:
1.
Open the cover to the pump chamber (3) by turning the bayonet coupling for the pump housing
(9) one quarter turn.
2.
Carefully remove the magnetic rotor (8) from the shaft (7). Pull as firmly as is necessary to
overcome the magnet’s force.
3.
Do not use any tools to clean the pump’s interior; simply rinse it out with warm water.
4.
Use a soft sponge to remove any residual dirt.
5.
Reassemble the fountain pump. Carefully replace the rotor on the shaft. When the rotor reaches a
certain position, it is pulled towards the pump housing by the magnet.
6.
Ensure that the ceramic washer (6) and the rubber gasket (5) are positioned correctly.
7.
Ensure that the O-ring (4) is correctly positioned before replacing the cover (3) for the pump chamber.
